Daily Video Blog

The T-finish Mistake
The T-finish Mistake
Authored by: Brady
Posted on: 13 June 2026

A lot of golfers grew up hearing the same advice: keep the head down, stay down through impact, and extend the arms as far as possible toward the target. The idea was that more extension meant a longer, lower path through the ball and more power.

Here's the catch. Reaching the arms all the way out pulls the upper body — torso, spine, head — forward with them. Once that much forward lean has happened, getting the club back up into a tall finish becomes a fight. Instead of folding naturally and rising up over the shoulder, the arms get yanked back around and in low, leaving the finish wide and deep.

Two long-time students ran into this not long ago. Both had worked for years on getting up into a clean finish, and both kept ending up a little too wide despite all that work. When the swings were broken down side by side, the cause was identical for both: over-extension through the ball.

One image that'... Read More

Authored by: Don Trahan
Posted on: 15 March 2012
Comments: 53
Lewis Shannon submitted a question to the website about lie angles. Because we are vertical swingers, Lewis asked if the lie angle of the club should also be vertical to match the swing. Well,... Read More
Authored by: Don Trahan
Posted on: 14 March 2012
Comments: 44
I received a question from a gentleman named Bob Knuth, who has had issues with both of his shoulders. He wanted to know if there was a way to make a good swing while limiting the usage of his right... Read More
Authored by: Don Trahan
Posted on: 13 March 2012
Comments: 60
With the Peak Performance Golf Swing, hitting a driver uses the same swing as hitting an iron. However, there are setup changes that are made, including ball position. Many golfers think that they... Read More
Authored by: Don Trahan
Posted on: 12 March 2012
Comments: 96
We're getting near the end of Doc's fitting series, but a few more important steps still need to be explained. Today, Doc talks about club configuration. In other words, Doc determines which clubs... Read More
Authored by: Don Trahan
Posted on: 10 March 2012
Comments: 92
In today's video, I'm going to show you how to adjust your setup whenever shaping a shot is necessary. This could happen for a variety of reasons. If there are obstacles in front of you or a pin... Read More
Authored by: Don Trahan
Posted on: 9 March 2012
Comments: 85
A question was sent in to the blog from Ken (from Middletown) asking what I thought about looking at the hole while putting instead of at the ball. Well, I know of a few pros who have tried this and... Read More
Authored by: Don Trahan
Posted on: 8 March 2012
If you have followed this blog for any length of time, you probably have heard me explain what led me to create the Peak Performance Golf Swing. If you haven't, then let me describe my motivation in... Read More
Authored by: Don Trahan
Posted on: 7 March 2012
Comments: 64
Today we have the latest installment of Doc Griffin's series on Custom Club Fitting. In this one, Doc talks covers all the important stuff on clubheads, from why size really does matter to why he... Read More
Authored by: Don Trahan
Posted on: 5 March 2012
Today I am going to cover the basics of how to hit a side-hill lie in response to a question from Tony Clark, of Reno, Nevada. "Surge: Would you please explain the stance and grip for hitting side-... Read More
Authored by: Don Trahan
Posted on: 4 March 2012
Comments: 1
In today's video I want to clear up a common problem of people confusing a chip for pitch shot. Jerry Shulman recently sent me an email in which he questions whether his problem with chipping comes... Read More